Jan 28, 2017 · You can cut the flat black ribbon cable on the gimbal and that will cut power to your gimbal motors. Dont cut the silver stranded cable, thats your video feed. If you decide to cut …

Feb 9, 2021 · Hello everyone After changing the Gimball on Mavic mini1 and Power ON, the Gimbal is not in the correct position with DJI Fly screen messages: Incompatible...

Apr 13, 2017 · The Gimbal base is sitting correctly where it should, rubber bands are all good, small flat cables look to be not broken. I have redone the IMU calibration, but It wont do a …

Dec 17, 2020 · The gimbal before I was able to fix the focus and aperture issue was moving left/right & up/down just fine. It can fly normally, but again, the camera is facing forward non stop.

May 11, 2025 · Tried a gimbal calibration and it would not complete past 60% I left it over night and this morning I have appeared to only make it work as now it says gimbal stuck and gimbal …

Jul 12, 2025 · Thank, the gimbal works perfect and very smooth. I have triple checked all connections. It's just video that is complete dead, mind that it did work perfect after …

May 22, 2025 · I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing …

Oct 4, 2020 · But when i got it home n flew it, the gimbal wont move and it shows me error code 40011. I can fly the drone properly without problems, but cant move the gimbal with the remote.

Jan 17, 2022 · Hi Guys, I've bought an Mavic Mini where the Ribboncable to the Gimbal Yaw motor driver board was broken/tattered. I've ordered an replacement cable and replaced it, all …

Jun 2, 2021 · If you replaced/repaired the gimbal on Air 2 / 2S as well Mavic 3 you can use the Python method to calibrate the camera but you will have errors 40011/40021 and 10016 after …